![]() xx - Specifies the major reason number (a positive integer, less than 256).If p or u aren't specified, the restart or shutdown is unplanned. U - Indicates that the reason is user-defined.P - Indicates that the restart or shutdown is planned.Lists the reason for the system restart or shutdown. If the timeout period is greater than 0, the /f parameter is implied. The valid range is 0-315360000 (10 years), with a default of 30. Sets the time-out period before shutdown to xxx seconds. This option must be used with the /r option.įorces running applications to close without warning users.Ĭaution: Using the /f option might result in loss of unsaved data. Goes to the Advanced boot options menu and restarts the device. This option must be used with the /s option.Ĭombining this option with a shutdown option causes the next restart to go to the firmware user interface.Įnables you to document the reason for an unexpected shutdown of a computer in the Shutdown Event Tracker. Shuts down the device and prepares it for fast startup. The /f switch can be used with the /h switch. Puts the local computer into hibernation, if hibernation is enabled. If your computer doesn't support power-off functionality, it will shut down when you use /p, but the power to the computer will remain on. Turns off the local computer only (not a remote computer)-with no time-out period or warning. Combine with /fw to clear any pending boots to firmware. This can only be used during the time-out period. After sign in, it restarts any registered applications.Īborts a system shutdown. On the next restart, if Automatic Restart Sign-On is enabled, the device automatically signs in and locks based on the last interactive user. After sign in, it restarts any registered applications. On the next boot, if Automatic Restart Sign-On is enabled, the device automatically signs in and locks based on the last interactive user. Logs off the current user immediately, with no time-out period. ![]() If /i is specified, all other options are ignored. The /i option must be the first parameter following the command. ![]() Syntax shutdown xx:yy ]ĭisplays the Remote Shutdown box. Read Command Line Parameters to try more commands.Enables you to shut down or restart local or remote computers, one at a time. To perform a Timed Force Restart, type in Shutdown –r –f –t 00. To perform a Force Restart, type in Shutdown –r –f. Your PC will reboot just as it would when you click Restart from the Start menu To perform a normal Restart, open Run (Start > Run) and type in Shutdown –r. Setting it to 05 will shutdown your PC after 05 seconds i.e after waiting for 5 seconds. This will Force Shutdown your PC in 00 seconds (waiting time). To perform a Timed Force Shutdown, type in Shutdown –s –f –t 00. Notice a new parameter –f? This parameter is responsible for Fore Shutdown. To perform a Force Shutdown, type in Shutdown –s –f. Your PC will shutdown just as it would when you click Shutdown from the Start menu To perform a normal Shutdown, open Run (Start > Run) and type in Shutdown –s. The same goes for Restart and Force Restart except for the base parameter ( -r instead of -s) Shutdown Force Shutdown with time set as a parameter, will force shutdown your PC at the specified time. ![]() Force Shutdown will stop all processes and forcefully shuts down your PC. Normal Shutdown is the term we’ve used here to mention the default Shutdown. Shutdown.exe is the process responsible for System Shutdown and Restart. This Command Line trick allows you to specify normal Shutdown/Restart or if you want to Force Shutdown/Restart and also allows you to specify the time to wait before Force Shutdown/Restart. If you’ve been using the power button to force shutdown your PC, try this Command Line trick to Force Shutdown and to Force Restart your PC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |